ELECTRICAL SYSTEM
BATTERY SERVICE NOTE: The electrical system in this machine is 24 volts. Each battery is 12 volts. Before you service components of the electrical system, always disconnect the NEGATIVE (-) battery cable. Do not run the engine with the battery cables disconnected or with the alternator wires disconnected. Before you use an electric welder, disconnect the alternator wires, instrument cluster, transmission electronic control unit and turn the master disconnect switch to OFF.
Cleaning the Batteries Check the batteries and battery compartment regularly for dirt, corrosion and damage. Dirt mixed with electrolyte or moisture on the top of the batteries can cause a discharged condition in the batteries. Use one of the following methods to clean the batteries. 1. Use Case Battery Saver, Part Number M20376. Follow the instructions on the container. This cleaner does not need water. 2. Use baking soda or ammonia and flush the outside of the batteries with water.
Do not use a steam cleaner or cleaning solvent to clean the alternator.
Battery Fluid Level The batteries are “Maintenance Free” type and electrolyte level check is not required. Do not leave lamps switched on for long intervals of time with the engine stopped or idling. Keep batteries clean, specially on its top surface. Make sure of that cable terminals are correctly fixed on the battery poles. Always disconnect master switch before servicing batteries.
Battery Vents Keep the battery vents clean, make sure the vents are not restricted.
132
If you do not have Case Battery Saver, use other special cleaners to prevent corrosion on the battery terminals.
