1 minute read
TRANSMISSION
Starting up after storage
Do not start the engine before carrying out the following operations: 1. Replace the fuel filter. 2. Fill the engine cooling system with engine coolant. 3. Check the condition of the alternator belt. Replace it if necessary. 4. Fill the engine with oil and check the oil level. 5. Check the hydraulic fluid level. 6. Check the transmission oil level.
7. Check the oil levels in the rear axle.
8. Check the oil levels in the front drive axle and reduction gears (4Wheel drive). 9. Grease all the machine’s linkages. 10. Use a paraffin-based solvent to remove the anti-corrosion product from the hydraulic cylinder rods. 11. Install the battery. 12. Fill the fuel tank.
13. Bleed air from the fuel supply system. 14. Check the condition and pressure of the tyres. 15. Start the engine.
WARNING : Check the machine for leaks and for broken, defective or missing parts.
WARNING : Before starting the engine, make sure all the controls are in the neutral position. This will prevent any unexpected movement of the machine and of any electrical equipment.
WARNING : Avoid running the engine in an enclosed space. Ensure adequate ventilation at all times.
289
TRIM THIS EDGE
RIGHT PAGE TRIM THIS EDGE
