Electrical systems – 5000 Parameters

11.11.8 Description of service parameters

# 10 - PIN code

NOTE:

The functionality of parameter #10 is ignored if the value of parameter #39 has been set to 5, 6, 7 or 8. PIN code input is facilitated via the extended keypad. For detailed information, see the section Extended keypad - General on page 49

The parameter stores the truck’s active PIN-codes. The truck can store up to ten PIN-codes. Each PIN-code has a set of parameters associated with it, called driver Parameters. Entering a particular PIN-code at start-up will make the selected PIN-code’s driver parameters active. This allows up to ten operators to individually adjust the characteristics of the truck.

On delivery the truck has one default PIN-code stored which is “1“.

To enter a new PIN-code:

•Operate L1 repeatedly in the forward direction to select parameter #10. After one second, the display will show the PIN-code for this driver.

•Repeat the step above until parameter #10 for the next driver is displayed, the display will either show PIN-code for that driver OR “0”(zero).

•Repeat the step above until the PIN-code displayed is “0” (zero)

•Press Horn button S18

Parameter symbol flashes.

•Operate L1 to set the desired value of the new PIN-code.1

•Press Horn button S18

Parameters symbol lights (stops flashing).

The new PIN-code has now been entered.

To remove an existing PIN-code:

•Operate L1 repeatedly in the forward direction to select parameter #10. After one second, the display will show the PIN-code for this driver.

1.Operating L1 lightly will step the value in increments of 1. Operating L1 fully will step the value in increments of 100. Valid values are 1 to 9999.