ASSEMBLY Assembly SPECIAL PRECAUTIONS To avoid physical injury and damage to the equipment: Read the installation, maintenance and repair procedures in the Repairs and Maintenance Manual.
2. Coat the thrust washers (304) generously with lithium grease. Fit the thrust washer (304) on the shaft (2) and the cap (4).
WARNING To avoid injury and damage to the product: Hold the product down firmly on a grooved work platform or in a vice.
WARNING Fluid projections: Contents under high pressure. Wear approved eye protection. Be careful when removing plugs and connections.
3. Install the exclusion joint (304.1) in the appropriate housings in the shaft (2) and the cap (4) around the external edge of the thrust washer (304).
ADVICE To avoid contaminating the wear parts: Be careful to work in a clean environment.
1. Before reassembly, gather all the parts and tools together in one place. Use the cutaway drawing as a reference for orienting the seals.
4. Fit the main pressure seal (205) on the shaft (2) and the cap (4) using a seal fitting tool (see “Tools required” on page 6). Use the tool for seals with a circular movement.
17
