Instrument Cluster

Air Filter Clogging Indicator

This is an Amber LED and glows when Air filter is clogged. This gives an indication to the customer that the air filter needs to be cleaned for proper functioning and beeper also give an audio warning.

Refer Beeper Output Provision in subsequent pages of this manual for Beep rate.

F-R Shuttle Switch Neutral Indicator

This is a Green LED and glows when F-R shuttle switch is in neutral position.

Air Pre-Heat Indicator

When the key is turned to ignition position, the cold start aid Indicator glows to indicate the activation of heater element provided in engine. Activation of this LED depends on Ambient temperature.

1.Turn the key to "ON" position and wait till the heater indicator is off.

2.Crank the engine when the heater indicator light is off.

NOTE : Engine runs at higher than idle rpm (about 1400 rpm) and drops gradually to the normal idling speed (850 rpm) until coolant temperature reaches to 770F (250C).

Fuel Level Gauge

The Fuel Gauge is displayed on the left side of rpm meter when viewed from the driver’s seat. It indicates quantity of fuel available in the fuel tank. The indication is divided into 9 stages. The Red zone indicates that the fuel level is less and the tractor should be refueled for uninterrupted run.

Low fuel indication & buzzer ON at 2nd Graduation & OFF at 3rd Graduation. Buzzer sound at the rate of 15 beeps per min.

Clutch Over Ride Indicator

Optional feature: This is an Amber LED and glows when clutch pedal is pressed for more than 10 sec. This symbol will glow if the feature is equipped.

High Beam Indicator

This is a Blue LED and glows when Head Lamps are operated in High Beam.

PTO Engaged Indicator

This is Amber color indication for PTO. This indicates when PTO is in ON position.

Turn Indicator

These are Green LEDs. LH and RH turn indicators are provided to indicate the direction of turning. A blinking LH turn indicator implies that the LH Turn Signal indicator of tractor is ON whereas a blinking RH turn indicator implies that the RH Turn Signal indicator of tractor is ON.

No. of flashes of these LEDs: 60-120 counts/minute

If the count is more than 140 per minute, then it is an indication that one of the bulbs is not functioning. Contact Mahindra authorized service dealer for rectification.

MIL Indicator

This indicator will glow when the engine is facing any issue with EMS system.

A malfunction in the electronic emission control system (ECU) is indicated by a continuously "GLOWING" or "BLINKING" Indicator, even past CRANKING of the engine. In such an event, get the problem rectified by an authorized Mahindra Dealer.

High Temperature Warning Indicator

This is a Red LED and is located on top of tachometer. It will glow continuously when temperature of coolant rises above 2300 F. The pointer of Temperature gauge will lie in the RED band under such condition. Also to warn the operator, A beeper will also give an audio warning. (60 beeps / Min)

Low Fuel Indicator

This is a Amber LED and glows when fuel in tank is lower than expected level.

Tachometer (RPM Meter)

This gives the number of Revolution per Minute of the engine. To arrive at the rpm value at any given point of time, multiply the pointer reading by 100.

Example: If the reading shows 15, the actual engine rpm value = 15 x 100 = 1500