CHAPTER 12 STORAGE After the harvesting season, store the Disc Mower Conditioner in a dry place where it is not exposed to weather or livestock.
2.
Remove any trash or debris which may have accumulated on the unit during storage.
3.
Check and re-inflate the Tires and re-torque the Wheel lugs.
4.
Readjust the Flotation Springs tension.
5.
Inspect Cutterbar Knives.
6.
Lubricate the entire machine following the information in the Lubrication chapter of this manual.
7.
Check Drive Chain tension following the information in the Service chapter of this manual.
8.
Perform the Clutch run in procedure as outlined in the Steps below.
BEFORE STORING Perform the following preparations on the Disc Mower Conditioner, before placing the unit into off-season storage: 1.
Conditioner in transport position and Transport Locks properly installed.
2.
Wash off the entire machine. Take special care to remove gum and accumulated dirt from the Cutterbar.
3.
Remove trash and debris which may be wrapped around Shafts and/or lodged against Bearings.
4.
Repaint any areas where the paint has been worn off or brush motor oil on these areas.
a.
Remove one of the Gearbox Steering Side Plates.
5.
Lubricate the entire machine following the information in the Lubrication chapter of this manual. BE SURE to change the Chain Drive, Gearboxes and Cutterbar oils. Apply motor oil to adjusting bolt threads.
b.
Loosen (but do NOT remove) the six Clutch Bolts (see Fig. 56).
c.
Place a block of wood between two Cutterbar Discs to prevent rotation.
Apply Shaeffer’s Silver Streak Lube or equivalent to the splined connection between the Upper and Lower Gearboxes. This requires lifting the Upper Gearbox about 6-8 inches (155-205 mm).
d.
Rotate the Driveline by hand until the Clutch slips.
e.
Tighten the six Clutch Bolts.
7.
Apply grease to any exposed Cylinder Rods.
f.
8.
Take note of any damaged or missing parts or attaching hardware; order and replace them during the off-season. Replace any damaged Curtains.
Install the removed Gearbox Steering Side Plate.
6.
9.
2
Check all hydraulic components, hoses and fittings for damage or leaks; make repairs or corrections, as required.
1
AFTER STORING After taking the Disc Mower Conditioner out of storage and before the start of the harvesting season, carefully check the unit over and make the following inspections and preparations: 1.
Replace all Guards, Shields and Covers. Review and re-familiarize yourself with all safety precautions outlined in the Safety chapter of this manual.
908151/AP0800
1 – Clutch Bolt (1 of 6) 2 – Gearbox Steering Side Plate
Fig. 56
48
Printed in U.S.A.
