Service and Troubleshooting
CAUTION: Avoid injury! Disks and S‐tines are sharp. Wear gloves and handle with care. Shield sharp parts during service work. • NEVER GO UNDERNEATH EQUIPMENT. Never place any part of the body underneath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak down, hydraulic system failures, mechanical failures, or movement of control levers can cause equipment to drop or rotate unexpectedly and cause severe injury or death. • Service work does not require going underneath. • Read the Operator’s Manual for service instructions or have service performed by a qualified dealer. To prevent or eliminate rust on disks and S‐tines or other ground engaging parts, apply a light coat of oil on them after each use. For rust appearing on any part of your machine, sand lightly and coat with enamel. Grease each bearing assembly before each use. Periodically check the disks and S‐tines. Remove any debris that might build up and restrict their performance. Periodically check tightness of all fasteners. Be sure to remove all unused seed from seed box immediately after use and clean with water to prevent corrosion.
