OPERATING INSTRUCTIONS - 5 Sync
Cruise
ON
Set
(+)/Res
(A)
(B)
(C)
Syn/Cru
Speed
Speed
OFF
Cancel
(-)
(D)
(E)
Figure 5-6 Sync/Cruise Control Panel (Typical)
CRUSADER SYNC/CRUISE - POSSIBLE OPERATOR CONCERNS Concern
Possible Cause
Corrective Action
Sync Lamp Flashing While Boat is Under Way
Slave throttle handle position is below the Master throttle handle position.
Place Slave throttle handle to the WOT position.
Cruise Lamp Flashing when Syn/Cru Mode switch is turned ON.
A previous cruise set speed remains in system memory.
Press Cancel on the Speed Set/Cancel switch (B). OR Use the Resume function (Switch C), then place the Master throttle in the WOT position to Resume previous Cruise mode function and Set speed.
Cruise Lamp Flashing while under way, Cruise Mode is enabled.
Engines are operating below the cruise Set speed.
Place the Master throttle to the WOT position.
The Slave engine is running slower than the Master engine and the Sync Lamp is flashing.
The Slave throttle position is below the Master throttle position.
Place the Slave throttle to the WOT position.
After re-starting the engines, the Slave engine does not speed up and follow the Master as the Master throttle is increased.
The Slave throttle position was not returned to the Idle/Start position before re-starting the engines.
Return the Slave throttle to the Idle/Start position then place the Slave throttle in the WOT position.
The Slave engine will not re-start with the Syn/Cru switch OFF.
The Slave throttle was not returned to the Idle/Start position before attempting to re-start the engine.
Place the Slave throttle in the Idle/Start position and start the engine.
34
L510001-09
