Shifting Transmission

CLEAR FLOOD (100%)

FULL THROTTLE (WOT) STARTING ORIDLE POSITION SHIFTING TRANSMISSION

CAUTION

Never shift the transmission into or out of gear unless the throttle is at the idle position. Shifting the transmission above 1000 RPM can severely damage the boat, transmission and engine.

1. Set the throttle lever at the idle position.

2. Move the transmission lever completely forward to shift into Forward gear.

3. Move the transmission lever completely backward to shift into Reverse gear.

4. Move the transmission lever to the center detent position to shift into Neutral.

Figure 5-3 Throttle Position Setting

NOTICE: If the Slave engine fails to start, ensure that the Sync/Cruise switch is OFF, if equipped, and the Throttle lever is at the start/idle position.

NOTICE: If engine still fails to start, contact your Crusader Marine Engines Dealer for service.

8. Check engine oil pressure immediately after the engine starts. If oil pressure is not within specifi cations (see Engine Specifi cations), immediately stop the engine and determine the cause.

9. Check voltmeter for proper charging system operation.

10. Check the engine and transmission for fuel, oil, water and exhaust leaks.

11. Allow the engine to reach normal operating temperature. Check the temperature gauge to ensure the engine is operating within the normal temperature range. If the temperature is abnormally high, stop the engine immediately and determine the cause.

FORWARD GEAR NEUTRAL

REVERSE GEAR

Figure 5-4 Shift Control