Crusader Sync/Cruise - Possible Operator Concerns CONDITIONS AFFECTING OPERATION ................................................................................. 35-36

Sync Cruise (D) (E)

ON Set (+)/Res

(A) (B) (C)

Syn/Cru Speed Speed

OFF Cancel (-)

Figure 5-6 Sync/Cruise Control Panel (Typical)

CRUSADER SYNC/CRUISE - POSSIBLE OPERATOR CONCERNS

Concern Possible Cause Corrective Action

Sync Lamp Flashing While Slave throttle handle position is Place Slave throttle handle to the

Boat is Under Way below the Master throttle handle WOT position. position.

Cruise Lamp Flashing when A previous cruise set speed Press Cancel on the

Syn/Cru Mode switch is remains in system memory. Speed Set/Cancel switch (B). OR - turned ON. Use the Resume function (Switch C), then place the Master throttle in the WOT position to Resume previous Cruise mode function and Set speed.

Cruise Lamp Flashing while Engines are operating below the Place the Master throttle to the WOT under way, Cruise Mode is cruise Set speed. position. enabled.

The Slave engine is running The Slave throttle position is below Place the Slave throttle to the WOT slower than the Master engine the Master throttle position. position. and the Sync Lamp is fl ashing.

After re-starting the engines, The Slave throttle position was not Return the Slave throttle to the the Slave engine does not speed returned to the Idle/Start position Idle/Start position then place the up and follow the Master as the before re-starting the engines. Slave throttle in the WOT position.

Master throttle is increased.

The Slave engine will not re-start The Slave throttle was not returned Place the Slave throttle in the Idle/Start with the Syn/Cru switch OFF. to the Idle/Start position before position and start the engine. attempting to re-start the engine.