STORAGE REMOVAL

1.Fill the fuel tank.

2.Tighten the cooling system drain valves.

3.Put coolant into the engine cooling system. 4.Check the engine oil level. 5.Check the condition of the engine fan belt and replace it if required. 6.Check the hydraulic fluid level. 7.Use a petroleum base solvent and remove the Case Rust and

Corrosion Preventive from the hydraulic cylinder rods and spools, etc.

8.Install a fully charged battery. 9.Remove air from the engine fuel lines.

10.Prime the turbocharger oil lines with oil using the following procedure:

A.Disconnect the electrical connector to the injection pump solenoid. This will prevent the engine from starting.

B.Make sure all persons are clear of the machine. Turn the key switch to START and actuate the starter for about 10 to 15 seconds.

C.Reconnect the wire to the injection pump solenoid. IMPORTANT: Before starting the engine, make sure there are no leaks, missing or broken parts. 11.Start the engine and run at idle speed for 2 minutes. Check for leaks around the filters and drain plugs. 12.Stop the engine and check the fluid levels of the engine cooling system and drive chain compartments.

See the Engine Cooling System and Drive Chain Compartment sections for the correct procedure on checking the fluid levels.