JOB SITE OPERATIONS
3. EQUIPMENT HYDRAULIC SYSTEM Wheel Loaders are shipped with Case TCH Hydraulic/Brake Fluid. Case TCH is formulated to provide top performance under most ambient temperature conditions. Case Low Temperature HyTr a n P l u s ® p r o v i d e s c o m p a r a b l e performance to TCH, but also provides superior viscosity characteristics at low temperatures. Choose the correct hydraulic/brake fluid for the ambient temperatures you will be working in (See Hydraulic/Brake System in this manual)
NOTE: A fully charged battery at 0˚F (-17˚C) has only 40 percent of the normal starting power. At -20˚F (29˚C) the battery has only 18 percent of the power remaining. Inspect the battery cables and terminals. Clean the terminals and apply electrical terminal sealers (See your dealer) to prevent corrosion. If you add water to the batteries and the temperature is below 32˚F (0˚C), make sure you charge the batteries or run the engine for approximately two (2) hours. This procedure will prevent battery freezing (See Batteries and Booster Battery connections in this manual.
4. FUEL SYSTEM - Check with your fuel supplier for the correct cold weather fuel. Engine power will be reduced if wax particles are in the fuel filters. Check for water in the fuel system. Cold temperatures can cause condensation to form in the fuel tank. Check the first stage fuel filter and fuel sediment bowl (if equipped) for water. If no water is found, extend the interval (see Diesel Fuel System in this manual).
Inspect the battery cables and terminals. Clean the terminals and apply electrical terminal sealer (see your dealer) to prevent corrosion. 2. LUBRICANTS - Make sure you follow the recommended oil and filter service for the engine and the hydraulic system as shown in this manual. Use the correct viscosity oil in each component for the ambient temperatures the machine is operated in (see Lubrication in this manual.
5. COOLING SYSTEM - Check the coolant mixture before you operate in cold temperatures. A mixture of 50% ethylene glycol and 50% water must be used in this machine. This mixture is used if the lowest ambient temperature is above 34˚F (-37˚C). If the ambient temperature i s l o w e r, a d j u s t t h e m i x t u r e . I t i s recommended that ethylene glycol and water be used in your machine all year (See Engine Cooling System in this manual). 67
TRIM THIS EDGE
RIGHT PAGE
Template Name: OM_1_col Template Date: 1994_04_29
1. BATTERIES/ELECTRICAL SYSTEM Clean the batteries and make sure the batteries are at full charge.
TRIM THIS EDGE
Cold weather conditions cause special problems. During these conditions your machine will require special start-up, and warm-up, and maintenance procedures for the best performance. Proper cold weather maintenance will extend the service life of your machine
Alt= to hide template information Alt+ to display template information
OPERATING IN COLD WEATHER
