Periodic Maintenance/Tune-Up
2. Remove the air filter knob; then remove the air filter. Account for the round air filter support. Remove the outer filter from the inner filter.
Tighten all nuts, bolts, and cap screws. Care must be taken that all calibrated nuts, bolts, and cap screws are tightened to specifications. It is advisable to lubricate certain components periodically to ensure free movement. Apply light oil to the components using the following list as reference. A. Accelerator Pedal Pivot/Cable Ends B. Brake Pedal Pivot C. Shift Cable
WT176A
SPECIAL TOOLS
A number of special tools must be available to the technician when performing service procedures in this section. Refer to the current Special Tools Catalog for the appropriate tool description. NOTE: When indicated for use, each special tool
will be identified by its specific name, as shown in the chart below, and capitalized. Description Compression Tester Kit Oil Filter Wrench Timing Light
p/n 0444-213 0644-389 0644-296
NOTE: Special tools are available from the Arctic
Cat Service Department.
Air Filter CLEANING AND INSPECTING FILTER
CAUTION
NOTE: Do not attempt to remove the inner foam from the wire mesh. It is part of the filter frame.
3. Place each element in a pan larger than the element and spray both sides generously with cleaning solvent; then let sit approximately three minutes. NOTE: Foam Filter Cleaner and Foam Filter Oil are available from Arctic Cat.
4. In a pan larger than each element, with mild detergent (dish soap) and water, wash all the dirt and oil off by squeezing or matting each element, not twisting it (wringing out or twisting the filter can cause damage). 5. Rinse off any remaining soap. 6. Remove any excess water from the elements by matting with a towel. 7. Allow the elements to dry completely. 8. Spray oil generously onto each air filter and work the oil into the elements. 9. Squeeze each element to remove excess oil. 10. Attach the foam filter to the inner filter screen.
Failure to inspect the air filter frequently if the vehicle is used in dusty, wet, or muddy conditions can damage the engine.
1. Unsnap the five fasteners securing the air filter housing cover and remove the cover.
WT179
CAUTION
WT006A
A torn air filter can cause damage to the vehicle engine. Dirt and dust may get inside the engine if the element is torn. Carefully examine the element for tears before and after cleaning it. Replace the element with a new one if it is torn.
7
