6 Maintenance
Draining of water from the water separator/fuel filter Every 100 operating hours.
The water separator is not engined mounted, but installed is required and the sensor must be connected.
9 Empty water separator
10 Bleeding
11 Start the engine
Empty the separately installed water separator:
After the water separator/fuel filter has been drained, the air has to be bled from the fuel system The fuel system is self-bleeding.
• Operate the starter switch until the engine fires; release the starter switch if the engine does not fire within 20 seconds.
• Disconnect the sensor connector (plug connection) • Unscrew the drain plug/sensor on the underside of the filter. • Allow the water to drain out and close the drain plug/sensor. • Reconnect the sensor connector.
Danger Do not smoke when draining off water and sediment. Keep flame and sources of ignition out of the area. Remove spilled fuel and litter before you start the engine.
• Wait until the starter motor has stopped before making a new attempt to start the engine. • Repeat the above if the engine cuts out after a short time.
45
