Section 7.Component Procedures

Model 9600/9700 Swing-Reach ® Lift Truck

Main Lift Cylinders (9700)Hydraulic Components

cylinder past the hydraulic fittings inside the cutout near the carriage. One technician guides the cylinder locating eye onto the pin on the mast.

5.Attach the hydraulic fittings at the bottom of the cylinder.

6.Secure the left side over-the-mast hose brackets under the carriage.

7.Clean and apply thread-locking compound (P/N1013829) to the threads of the cylinder mounting stud. Install the nut and torque to 50 ft. lb. (67.7 Nm).

8.Reconnect the battery connector and turn the key switch ON. Slowly and carefully extend the piston using the lift function. Continue to elevate the piston until the piston engages the telescopic.

9.Clean and apply thread-locking compound (P/N1013829) to the threads of the top mounting stud. Install the nut and torque to 50 ft. lb. (67.7 Nm).

10.Attach the left side over-the-mast hose pulleys and route hoses over the pulleys.

11.Remove blocking beneath the carriage. Lower the carriage completely.

12.Install hose and cable slap pads.

13.Bleed the hydraulic system. See “Bleeding the Hydraulic System” on page7-74.

14.Check hydraulic fluid level and refill as needed.

15.Shim cylinders as required. Refer to “Main Lift Cylinder Shimming” on page7-83.

Publication: 1089040, Issued: 08 Apr 2016