REPAIR INSTRUCTIONS

1.Install a new filter O-ring and bronze filter into the filter bore of the housing. Set the filter on top of the O-ring.

3.Install the top cover over the range shift valve body. Install cover screws and tighten the screws to the specified torque.

Lightly lubricate the O-ring before installation. Overlubricating the O-ring may cause filter restriction. Make sure to properly seat the O-ring.

2.Position a new top cover seal (if required) into the groove of the top cover. Lightly lubricate the seal before installation, and make sure all portions of the seal are properly seated in the grooves.

4.Set the assembly aside for later installation onto the main case shift cover.

Two-Position Range Shift Cylinder

1.Install a new O-ring into the groove in the shift rail bore.

2.Form the Teflon® seal into a kidney shape as shown in Figure 443.

3.With the nose of the range shift cylinder Teflon® seal inserter (tool No. J 47357) retracted, place the seal in the nose the tool and then push the fold outward to make it sit as flat as possible in the nose.