REPAIR INSTRUCTIONS

91.Install the interlock O-ring, pin, spring and sleeve into the main case shift cover.

On the very rare occasion of clutch tooth contact, the noncurrent eccentric pivot pin, which is available for service should be installed. Adjustment of the eccentric pivot is as follows: a.Loosen the locknut on the eccentric pin. While rotating the transmission input shaft by hand, adjust the eccentric pin until gear clash occurs. Note the position of the eccentric pin. b.Turn the eccentric pin in the other direction until gear clash occurs again and note the position of the eccentric pin. c.Return the eccentric pin to a point midway between the two positions. d.Tighten the locknut to 54–68 N•m (40–50 lb-ft).

92.Position the range shift valve over the tip of the interlock pin. Install the two (outer) Allen-head 5/32-inch screws and torque to specification.