REPAIR INSTRUCTIONS

67.For the extended output shaft transmissions: T313–T318(21)(L21)(LR21), install a new gasket onto the output housing and then install the housing onto the rear case. Note the location of the lubrication hole.

69.On the extended output shaft transmissions: T313–T318(21)(L21)(LR21), install the collapsible-type spacer (the correct length of the spacer was previously determined in “Rear Output Housing Reassembly: T313–T318(21)(L21)(LR21)” on page 142). Also install the outer bearing cone into the output housing over the output shaft.

68.Install and tighten the output housing capscrews to the recommended torque specification.

70.Seat the outer bearing cone and spacer, using a blunt punch and hammer. Working in a circular motion, tap lightly around the inner race of the bearing cone only.