REPAIR INSTRUCTIONS

22.Continue removing the friction and reaction discs until all are removed.

23.Remove the shaft snap ring from inside the Lo-range gear hub.

25.Remove the larger snap ring that secures the Lo-range gear to the gear hub.

24.Remove

26.Remove the Lo-range gear from the hub. Notice that the ground surface on the gear faces the front of the transmission.

27.Remove the Lo-range gear hub from the rear mainshaft.

28.On the extended output shaft transmissions: T313–T318(21)(L21)(LR21), position the output shaft in a suitable press. Separate the tapered roller bearing cone from the shaft, using bearing separator J 8176 or equivalent.

30.On the conventional output shaft transmissions: T313–T318(L)(LR), using a suitable bearing puller, remove the spigot bearing from the front end of the rear mainshaft.

29.For the conventional output shaft transmissions: T313–T318(L)(LR), remove the spigot bearing snap ring from inside the front end of the rear mainshaft.

1. 12-Point Screw

2. Nonthreaded Insert

3.

4.

5.

6.