5-101.bk Page 18 Friday, March 17, 2006 11:05 AM
200 ENGINE ASSEMBLY DIAMOND-SHAPED DOWEL PIN INSTALLATION
BLADE-TYPE DOWEL PIN INSTALLATION
Refer to Figure 6-19. 1. Position the two alignment studs (3) in the threaded holes (2) nearest the right dowel location hole (6) in the cylinder block (1). 2. Position the diamond-shaped dowel pin (5) in the diamond dowel aligner J 37711 (4). 3. Position the diamond dowel aligner with the pin in position on the two alignment studs (3). 4. Using a hammer, drive the dowel pin into the hole until it bottoms out in the block. 5. Remove the diamond dowel aligner and the two alignment studs. The dowel pin will be at the correct height above the block. 1
2
3 4 5
6
2 3
200336a
Figure 6-19 — Diamond-Shaped Dowel Pin Installation 1. Cylinder block 2. Threaded holes 3. Alignment studs 4. Diamond dowel aligner
Page 6-18
5. Diamond-shaped dowel pin 6. Dowel location hole
1. Position the round end of the blade-type dowel pin into the dowel pin hole in the cylinder block. The blade end must be aligned vertically with the block. 2. Using a hammer, drive the dowel pin into the block until the shoulder of the pin is flush with the cylinder block surface.
