200 ENGINE ASSEMBLY

DIAMOND-SHAPED DOWEL PIN INSTALLATION

Refer to Figure 6-19.

1.Position the two alignment studs (3) in the threaded holes (2) nearest the right dowel location hole (6) in the cylinder block (1).

2.Position the diamond-shaped dowel pin (5) in the diamond dowel aligner J 37711 (4).

3.Position the diamond dowel aligner with the pin in position on the two alignment studs (3).

4.Using a hammer, drive the dowel pin into the hole until it bottoms out in the block.

5.Remove the diamond dowel aligner and the two alignment studs. The dowel pin will be at the correct height above the block.

BLADE-TYPE DOWEL PIN INSTALLATION

1.Position the round end of the blade-type dowel pin into the dowel pin hole in the cylinder block. The blade end must be aligned vertically with the block.

2.Using a hammer, drive the dowel pin into the block until the shoulder of the pin is flush with the cylinder block surface.