Control, operation

Press switch S16 down. Parking brake is engaged. Indicator light in the switch illuminates. Switch off the engine, push the safety lever up. Secure the superstructure on the chassis using the pillow block. Push the safety lever down.

Turn the ignition key to the contact position and relieve pressure lines by moving the joystick carefully several times.

Remove the ignition key and push the safety lever up. Close and lock all doors, covers and panels on the machine. Fold in the mirror.

To secure the machine: The machine must be secured against slipping before starting the journey.

1 Dozer blade

Danger!

2 Claw support

Serious accidents can occur if the machine is allowed to slip on the loading ramp. Secure the machine against slipping.

To do this, use chocks and a tension cable or tension chains.

Secure the machine at the points provided for the purpose using tension cables or tension chains. The "anchor points" are identified by an information plate. Secure tension cables and tension chains on the low loader according to type.

Transport route:

Danger!

Driving beneath obstacles which are too low can cause serious accidents. Drive under obstacles, particularly electrical lines, with increased caution.

Find out about the route to be travelled before starting the journey.

3.7.3Loading the machine with a crane

If the machine is to be loaded using a crane (eg. on to ships or rail freight cars), the type of suspension should be selected according to the equipment.

Danger!

The load could slip or fall if incorrectly loaded.

Only permit experienced personnel to secure loads and signal the crane driver. The signaller must position himself within the view of the operator or be in voice contact with him.

Ensure that the length of the suspension gear is sufficient.

Loading a machine with a gooseneck boom:

Suspending the machine with gooseneck boom

Only use cargo handling gear which is sufficiently dimensioned or which has been specially developed by LIEBHERR for this purpose.

Lower the equipment, draw in the stanchion and tip the bucket as far as the stop. Press switch S16 down. Parking brake is engaged. Indicator light in the switch illuminates.

Switch off the engine, push the safety lever up. Secure the superstructure to the chassis using the locking pin. Push the safety lever down.

Turn the ignition key to the contact position and relieve pressure lines by moving the joystick carefully several times. Remove the ignition key and push the safety lever up. Close and lock all doors, covers and panels on the machine. Fold in the mirror.

Attach the cargo handling gear to the points provided for the purpose.

Danger!

Standing under the raised machine is not permitted!