3 minute read
Air System Conne~ons Misassembly Loose Connectors Hoses Leskinfl
7. HYDRAULIC ;)ILTEMPERATURE ALARM LAMP
ON - Lamp illuminates when Hydraulic OiITemperature is 3°C (26.6°1=) or lower. OFF- Lamp goes out when Hydraulic Oil Temperature reaches 10°C (40°F). Normal operating temperature of hydraulic oil is 45°C -
55°C (113OF - 131OF).
8. DOZER CONTROL
To energize solenoid for flow divider valve.
15.WORK LIGHT SWITCH (EUROPE SPEC)
~Depress this Depress this side of switch to turn on all side of switch to turn off all work lights. work lights.
16. ROTARY LIGHT SWITCH (EUROPE SPEC)
~Depress this side of switch to turn onrotarylight. Depress this side of switch to turn off rotary light.
9. HEAT & AIR CONTROLS 17. HORN SWITCH
Located on top of L.H. Operator Control. Depress to sound horn. Release to stop sounding of horn.
C ~E 18. ENGINE EMERGENCY STOP CONTROL
"~’~: Located at lower R.H. side of operator seat. Pull control out to stop engine in case oj= emergency
A - FANSWlTCH 1. OFF Turn switchcountemlockwise to left most position. 2. LOW Turn switch clockwise to first dot. 3. MEDIUM Turn switch clockwise to second dot. 4. FAST Turn switch clockwise to third dol
B - PLUGS - To allow installation of optional equipment.
C - HEAT TEMPERATURE CON-
TROL
Pull control "UP" to reduce the flow of warm water to heater core. Push control down to increase flow of warm water to heater core.
D- INSIDE/OUTSIDE AIR
CIRCULATION CONTROL
Pull control up to circulate outside air into cab.
Push control down to stop circulation of outside air into cab.
E- DEFROSTER SELECT CONTROL
Pull control up for air circulation from under seat.
Push control down for air circulation behind seat.
10. 24V CIGARETTE LIGHTER
ON - Push in. OFF- Lighter "POPS" out. The lighter should pop out within 30 seconds. If it doesn’t, have it repaired. Do not use lighter for a 12V power source.
11.12V POWER SOURCE
To allow use of accessories requiring a 12VDC power source.
12. AUTO DECELERATION SWITCH (Europe ONLY)
Depress this side to turn Auto Decel "ON", This will drop engine RPM to 1050, -- Depress this side to turn Auto Decel "OFF".
13. TRAVEL ALARM CANCEL SWITCH
Depress again to turn Travel Alarm "OFF" Always useTrevel Alarm during allTrevel Operations
14. ENGINE START AID ICON
This icon will display after keyswitch is turned to "HEAT" position.This system serves to warm the engine air intake when starting in cold climates.
19. FUEL LEVEL METER
F- Full tank, approximately 250 liters (66 Gal.)
e~ E- Empty tank, approximately 3 liters (8 Gal.) of fuel in Tank.
20. ENGINE COOLANTTEMPERATURE METER
~~e RED- Indicates engine coolant temperature is above safe operating temperature. Reduce engine RPM or stop engine and allow to cool. WHITE-Engine safe operating temperature range. BLUE- Engine cold range.
21. ENGINE HOUR METER
10 I01 01 01 01 01 Indicates actual hours engine has ran.
B
22. FUEL LEVEL LAMP
I~ Illuminates when fuel tank level is 14 liters (3,7 Gal.) or less. Refuel immediately if Fuel Level Lamp is illuminated.
23. ENGINE OIL PRESSURE LAMP
ilp~
Illuminates when Oil Pressure is below safe operating pressure. Stop Engine Immediately and check oil level if lamp comes
on during operation of the machine. 24. BATTERY CHARGE LAMP
!~"~ Illuminates when electrical properly. charging system is not functioning Check the charging system if light comes on during operation.
25. ENGINE COOLANTTEMPERATURE LAMP
Illuminates when engine co°lent temperature rises ab°ve 105°C (211°F)" If lamp comes on reduce engine RPM immediately and stop operation to allow engine to cool down to safe operating temperature.
26. HIGH TRAVEL SPEED LAMP
1~ Illuminates when the Travel Speed Select switch is "ON".
27. DIRTY ENGINE AIR CLEANER LAMP
P,~dl u Illuminates when engine air cleaner element(s) are full of debris. If illuminated, clean or replace element(s) immediately.
