Attachment and Auxilliary Hydraulics Pilot-Pressure Apply Valves
LOCKING KNOBS
AUXILIARY HYDRAULICS PILOT-PRESSURE APPLY VALVE
ATTACHMENT TILT PILOT-PRESSURE APPLY VALVE LOCKING KNOBS
AUXILIARY HYDRAULICS SPEED CONTROL KNOBS
L71378 DECAL
FRONT
ATTACHMENT TILT REARWARD SPEED CONTROL KNOB
Frame Level Control: This control is located to the rear of the tri-function joystick. The machine may be tilted slowly as much as 10° to the left or right to level the frame and boom in relation to the ground.
ATTACHMENT TILT FORWARD SPEED CONTROL KNOB
L71378 DECAL
WARNING For maximum machine stability, never lower the outriggers so that the tires come completely off the ground.
WARNING
Do not use outriggers on soft or uneven surfaces. Be sure the surface can support the machine and load.
DO NOT level the frame with the boom raised or extended. Only level the frame while stopped and with the boom fully retracted and the attachment raised just enough to clear the ground.
Be sure NO persons or equipment are where the outrigger pads will be positioned. DO NOT travel with the outriggers extended under any circumstances.
Outrigger Switches: The outriggers are used to provide greater stability in specific applications. Press the left switch forward to lower the left outrigger. Press the right switch forward to lower the right outrigger. Press both switches rearward to raise the outriggers.
Adequate clearance is required for the outriggers in the retracted position when traveling through doorways or narrow pathways. DO NOT attempt to use outriggers as a hydraulic jack for maintenance or frame leveling or other similar uses.
Level the frame before lowering the outriggers. Lower the outriggers until the front tires just start to raise.
Failure to heed could result in death or serious injury.
PRINTED IN U.S.A.
29
913325/AP0311
