Electrical System Problem
Starter will not engage when key is turned to START.
Work lights not functioning properly.
Lift/Tilt and/or drive lock solenoids do not work.
54
Possible Cause
Remedy
Seat, restraint bar switch or neutral auxiliary hydraulics is malfunctioning or not activated.
Replace switches as needed. If engine still doesn’t start, contact your dealer.
Poor connections to starter relay in instrument panel.
Verify relay connections.
Battery terminals or cables loose or corroded.
Clean terminals, cables and retighten.
Faulty starter relay in instrument panel.
Contact your dealer.
Battery discharged or defective.
Recharge or replace battery.
Starter solenoid not functioning.
Troubleshoot circuit. Replace the starter solenoid.
Ignition wiring, seat switch, restraint bar switch, etc. loose or disconnected.
Check wiring for poor connections, broken leads; repair wiring or connection.
Starter or pinion faulty.
Remove starter; repair/replace as needed.
Single light doesn’t work: Light bulb burned out, faulty wiring.
Check and replace light bulb as needed. Check wiring connection to light.
No lights at all; circuit breaker tripped.
Check circuit and locate trouble before replacing fuse.
Faulty light switch or poor ground.
Replace light switch. Check ground wire connections.
Wiring to solenoids disconnected or faulty.
Troubleshoot circuit, repair.
Faulty seat or restraint bar switch.
Contact your dealer.
Faulty solenoid valve coil.
Contact your dealer.
Faulty hydraulic solenoid relay in instrument panel.
Contact your dealer.
917388/G0521
