Left Hand Face Configuration

D I S P L A Y G L O S S A R Y

:Default Displays:

Following are the displays that can appear on the PMC-R as the default in different situations.

#123 Shearer Zone

Default display: this shield is in the shearer safety zone

#123 -Wedge Advance

Default display: shield is in wedge advance group

#123 -Tapered Push

Default display: shield is in tapered push group

#123 -Wedge -Taper

Default display: shield is in wedge advance group and in tapered push group

#123 BTP Lockout

Btp Control lock button is pressed.; no push allowed on these shields.

#123 SYSTEM TRIPPED!

Default display: system is tripped; to reset system, press Start key and then P key.

#123 Network! SRV-150

Default display: network is broken - communications is successful over range shown. Probably caused by broken shield to shield cable or network params are set wrong.

#123 No Net Number

Default display: SCU has no network number due to invalid parameter settings in Configuration->Network section or due to faulty cabling. Can be numbered manually using D-Enter.

#123 No Network

Network is not correctly established. Check network parameters in Configuration>Network section.

SRVR BTP Station Lost

Unrecognized signal from Belt Tailpiece Control.

#123 < ULOCK 4 More

© Caterpillar