OPERATING INSTRUCTIONS RH 400 Inspection and servicing Ü Withdraw plate assembly (12, Fig. 3-26:) from rotor (13).
Cleaning the centrifuge Ü Check the inside of the rotor housing.
The plates may have sharp edges.
Ü Remove any dirt deposits without damaging the surface of the rotor housing. If necessary, clean all centrifuge parts in diesel fuel. Remove all residual dirt particles with compressed air or an air/water pistol. Adhering dirt unbalances the rotor and may damage the bearings.
Assembling the centrifuge
The plates (16, Fig. 22) have 4 possible opposing positions. Fig. 3-26:
Ü Remove clip (14, Fig. 3-27:) and distributor plate (15).
Ü Place paper filter into the rotor cap (4, Fig. 3-26:):
Ü Remove plates (16) and end plate (17) from distributor (18) .
Ü Assembly is done in the reverse sequence to dismantling. Ü Run engines at idling speed for a short time and check centrifuge for leaks. Ü Shut off engines. Ü Check oil level after ca. 10 minutes; top up if necessary.
Fig. 3-27:
3-45
BA RH400(3 659 450.00)-EN
