2 minute read
Oil Pan
FUEL TRANSFER PUMP
8. Use tool group (A) to install the check valve in head (11) until it makes contact with the shoulder in its bore. Make sure the spring on the check valve is toward the inside before it is installed.
9. Put gasket (12) and head (11) in position on the plate and install the two bolts that hold the pump together.
10. Install the relief valve poppet (13), spring (14), the seal washer and cap (15) in the pump.
11. Install O-ring seal (16) around the pump and put clean engine oil on it.
12. Install drive coupling (17) on the pump shaft. end by: a) install fuel transfer pump
OIL PUMP
REMOVE OIL PUMP 1304-11
start by: a) remove fuel transfer pump
1. Drain the coolant from the cooling system.
2. Drain the oil from the oil pan.
3. Remove all bolts (1) and (2) to remove adapter (3) from the engine.
4. Remove all the bolts and remove oil pump (4) from the engine. The weight of the pump is 39 kg (85 lb.).
INSTALL OIL PUMP 1304-12
NOTE: The oil pump shaft must turn by hand and the pump must have oil for lubrication before it is installed.
1. Put clean engine oil on the O-ring seals and put oil pump (1) in position. Make sure the splines on the pump shaft are correctly engaged with the splines of the oil pump drive. Install the bolts to hold the oil pump in position.
2. Put the gaskets and adapter (2) in position. Install the bolts to hold the adapter and gaskets in position.
3. Fill the engine with oil to the correct level.’
4. Fill the cooling system with coolant to the correct level. end by: a)install fuel transfer pump
288
OIL PUMP
DISASSEMBLE OIL PUMP 1304-15
Tools Needed A 1P510 Driver Group 1 start by: a) remove oil pump
1. Remove adapter assembly (1) from the pump.
Cover (2) has spring tension on it. Loosen the bolts that hold it slowly and the same amount to remove the tension on the cover.
2. Remove the bolts, cover (2), gasket (3), spring (4) and valve spool (5) from the pump.
3. Remove cover assembly (6) and the gasket from the pump.
4. Remove cover assembly (7) from the pump.
289
OIL PUMP
5. Use tooling (A) to remove bearings (8) from cover assembly (7).
6. Remove shaft assemblies (10) from body assembly (9).
7. Use a press to remove gears (11) from the shaft assemblies.
8. Use tooling (A) to remove bearings (12) from body assembly (9).
