ent pump during reverse travel with locked traveling drive. Speed [rpm] 4-4 Pressure (bar) at measuring point G X2 MA X1 MB Idling speed (approx. 1000) 32 <2 25 4.7 26.4 1350 32 <2 25 8.8 110 1600 32 <2 25 11.8 215 2390 32 <2 25 18.3 410 SHB WL44 / WL54 * 1.08e:T41c,Traveling drive 4 Variable displacement pump Pressure values A4VG71DA (30 km/h version) Information Specified values are approximate values and can vary from loader to loader. The values serve as an orientation during troubleshooting. Variable displacement pump during forward travel Information This table provides the pressures of the variable displacement pump during forward travel with locked traveling drive. Speed [rpm] Pressure (bar) at measuring point G X2 MA X1 MB Idling speed (approx. 900) 31.1 1 28 <2 28.6 1350 30.5 8 204 <2 26.4 1600 31.5 12.5 304 <2 27.7 2310 32.8 23.8 447 <2 28.3 Variable displacement pump during reverse travel Information This table provides the pressures of the variable displacement pump during reverse travel with locked traveling drive. Speed [rpm] SHB WL44 / WL54 * 1.0 Pressure (bar) at measuring point G X2 MA X1 MB Idling speed (approx. 900) 31.1 <2 28.6 4.7 28 1350 31.1 <2 27.5 8.1 217 1600 32 <2 28.6 12.1 304 2310 33 <2 29.4 23.3 447 4-58f:T537,Traveling drive 4 Variable displacement pump Checking/adjusting the inching Information Pedal travel “X” during which the loader rolls backward, should exist, but be as small as possible. Checking 1. Stop the loader on an upward slope with the help of the service brake. 2. Maintain travel direction and apply full throttle. 3. Slowly release the service brake until the loader begins to roll backward. 4. Continue releasing the service brake until the loader begins to travel forward. 5. Adjust the inching if necessary. Adjustment 1. Remove cap – see “Overview A4VG56DA (20 km/h version)” on page 4-2 or Overview A4VG71DA (30 km/h version) on page 4-3, position 7. 2. Loosen t