Installation procedure, helm
EVC-C
EVC system display
The EVC display kit consists of the display with connection and a cable, length 1.5 m (5 ft) with 12- and 6-pin connections. An extension cable may be used, lengths: 1.5, 3, 5, 7, 9, 11 m (5, 10, 16, 23, 30, 36 ft). Please refer to the Connection section on the next pages. DISPLAY CONN. Part No.
X5 MULTILINK Yellow
IMPORTANT! An EVC system display can be connected together with a tachometer. The display can also substitute a tachometer. The EVC system must have either a tachometer or a display. The following information is available in the EVC display: -
-
Coolant pressure Fuel pressure Fuel level Engine oil pressure Turbo pressure Coolant temperature Transmission oil pressure Voltage Exhaust temperature Engine oil temperature Transmission oil temperature Engine rpm Engine running hours Boat speed Fuel rate Engine power trim Sea water pressure Trip data: (fuel rate, fuel consumption, fuel consumption/time, trip fuel consumtion, trip fuel consumption/time, remaining fuel, trip hours, trip distance, remaining distance to empty tank, remain ing time until tank is empty) Sea water depth Sea water depth alarm Sea water temperature Rudder angle Engine oil filter differential pressure
Information is depending on engine model, number of sensors and type of accessories.
52
IMPORTANT! Always connect instruments and senders which are common for both engines, such as speedometer, rudder indicator etc to port HCU. The port engine is the master engine in the EVC system. NOTE! In a twin installation the default setting of the display will show port engine data. Please refer to the EVC system display/Calibration and settings chapter for further information. IMPORTANT! In a twin installation, when using one combined EVC system display, the display must be configured as a “TWIN” before auto configuration is performed. In a twin installation, when using two EVC system displays, the displays must be configured as “PORT“ resp. ”STARBOARD” before auto configuration is performed. NOTE! The EVC-C system allows maximum one display per helm station (HCU).
Location and fitting NOTE! Allow adequate clearance behind the display for cable connection to ensure that the cable is not unduly stressed. Also ensure that there is sufficient length of cable to remove the unit for servicing purposes. The instrument is usually installed on a dash board. It can be mounted from above or flush from under the dash board. Flash mounting demands tailor made fittings. Templates are included. Please refer to the Templates for controls and panels chapter. NOTE! Cut out dimensions are nominal only and should be checked against physical units prior to machining.
