Control/computer equipment – 8700

•“Voltage analog input 2, pin13”- The measured DC input signal (1) from the steering potentiometer.

•“Current” - the measured current supplied to the steer servo motor in Ampere

•“Actual velocity” -The measured rotational speed of the steer servo motor shaft in r.p.m.

18.10 Other menu functions

18.10.1

Save to file

The truck parameters can be saved in the PC for downloading at a later date.

Select <File | Save to file | Parameters >. All parameters in the nodes which are connected to the bus will be scanned in and saved in a file. If only the hour meters are needed, select <File | Save to file | Hour meters >.

18.10.2

Download from file

A set of parameters can be downloaded from the PC to the truck. Select <File | Load from file | Parameters >. The parameters in the file will be copied to the nodes connected to the bus. If only the hour meter settings are needed, select <File | Load from file | Hour meters >.

18.10.3

Reset CAN adapter

If problems should occur when resetting the CAN adapter connected to the PC, this can normally be done manually by making sure that the adapter is supplied with voltage and then selecting <Nodes | Reset CPC-PP >.

18.10.4

Delete error code log

To delete the truck’s error code log, start the truck in parameter mode and then select < Tools | Erase error log >.

18.10.5

Reset hour meter

To reset the truck’s hour meter, start the truck in drive mode and then select < Tools | Reset hour meters >.

18.10.6

Read error code log

To show the truck’s error code log, select < Tools | Read error log >.

18.10.7 Adjust date and time

To quickly adjust the truck’s data and time, select < Tools | Adjust date & time >. The time given in the PC will now be downloaded into the truck.

NOTE!

This does not apply to trucks without a real-time clock.

18.10.8 Adjusting the hour meter on older cards

To adjust the hour meter on trucks with older cards, select < Tools | Adjust Hour meters >. The time given in the PC will now be downloaded into the truck.

18.10.9 Help About the TruckCom application

To see program information, select <Help | About TruckCom... > or use the tool button [Information].

18.10.10

Exit

To exit the program, select <File | Exit > or use the tool button [Exit].