Electrical System – 5000

14.3 Operating description

14.3.1 Starting truck

To enable the truck to be started, the battery plug must be connected, the emergency switch (S21) closed and the start key (S17) in the ON position.

14.3.2 Driving speed ≤ 6 km/h

When driving at a speed of 6 km/h -the switch for driving brake (S10) must be closed, and the -Speed controls must be activated in any direction.

14.3.3 Braking in neutral mode

•when the speed controls are in neutral mode, the engine functions as a generator. The braking energy is fed back to the battery.

•The brake (Y1) is engaged when the truck stops completely even if the tiller arm is in drive position.

•Energy is fed back to the battery (see diagram below).

•The transistors (T2) for the brake circuit generated are not live.

14.3.4 Braking in neutral mode on a slope

If the driver releases the speed control on a slope and the truck does not stop within a certain space of time, the electrical brake is automatically engaged.

14.3.5 Braking

The brake is always engaged when the truck is started with the tiller arm in the top or bottom position (S10 open). The brake is released once all the requirements for driving have been fulfilled, and the truck begins to move.

Requirements for the truck to be able to brake:

•S10 open.

14.3.6 Lifting the forks

•S34

•S31 closed.

•Battery status OK (if battery capacity remaining is > 20 %).

14.3.7 Lowering the forks

•S41 activated.

14.3.8

Horn

•S18 activated.

14.4 Hour meter

•Press and hold S18 while turning S17 to “ON” position.

•Press and hold S18 until H = hour meter is displayed.

•You have now selected H = hour meter. The “B” symbol lights up.

•You can now select type of hour meter by pressing the speed control.

Error codes

•Press and hold S18 while turning S17 to “ON” position.

•Press and hold S18 until E = error codes is displayed.

•When E is selected, the “E” symbol will light up as an indication of what is shown in the display.