Electric drive motor – 1760

Service/Repairs

9.1.2 Assembling

Assembling is carried out in the reverse order.

•Carefully lift down the motor in the drive gear to avoid damaging the seals and gear wheels.

•Tighten the nuts on the studs to the prescribed torque, 26.6 Nm.

•Fit and adjust the brakes as per the instructions. Screw tight the cover and tiller arm, and connect the cables that were previously removed. Check that the polarity is correct.

•The function of the brakes should be checked before the truck is moved.

9.2 Service/Repairs

9.2.1 Dismantling of motor

•Release the brake disc’s companion flange by first removing the locking ring together with the washer in the end of the rotor shaft. The companion flange can now be lifted off. It may be necessary to unclamp it with an appropriate tool.

•Remove the four plugs that cover the carbon brushes, move the springs on the carbon brushes to one side and pull out the carbon brushes.