Tigercat 875 LOGGER SERVICE MANUAL SN 8750501 TO 8752000 - PDF DOWNLOAD

Page 33

Tigercat 875 Logger Before performing work under the boom system ensure it is firmly supported. When opening or closing the power operated engine door, watch for personnel in door areas. If the engine is running inside a building, ensure that sufficient ventilation is available to prevent a build-up of toxic exhaust fumes. Run the engine only when it is necessary for testing or adjustments.

Work in a ventilated area. If it is necessary to run an engine in an enclosed area, use an exhaust pipe extension to remove toxic exhaust fumes. If you don't have an exhaust pipe extension, either work outside, or open the shop doors.

Safety FLUID INJECTION INJURY

Hydraulic and diesel fuel systems on forestry machines operate at very high pressures, often 207 bar (3000 psi) and above. If a loose connection or a defect in a hose should occur, a fine, high velocity stream of fluid will result. Even for systems pressurized to as little as 7 bar (100 psi), this fluid stream can penetrate human skin as if it were a hypodermic needle.

Initially, an accidental fluid injection beneath the skin may only produce a slight stinging sensation. There is a danger that you will tend to ignore this, thinking that it will get better with time. Most often, it does not! Within a very short time the wound may begin to throb painfully, indicating that tissue damage has already begun. Similarly fluid injected directly into a blood vessel can spread rapidly through your circulatory system. The human body has little ability to purge injected fluid. Diesel fuel or hydraulic oil under pressure can penetrate the skin and could result in death or serious injury. If any fluid is injected under the skin, a medical doctor familiar with the treatment of this type of injury must surgically remove it within a few hours.

Dispose of fluids properly. Do not pour fluids into the ground, stream, pond, lake, ocean or any body of water. Before draining any fluids, know the proper way to dispose of them. Dispose of the waste fluids according to local regulations. When performing required hydraulic checks and speed adjustments install any attachment guards provided if equipped. Refer to ATTACHMENT MANUFACTURER'S MANUAL for instructions. Read, understand and follow all operating safety precautions specified by the ATTACHMENT MANUFACTURER.

WARNING

Time becomes critical as tissue damage progresses rapidly. The longer you delay getting professional medical attention, the more damage can occur. Although fluid injection accidents are rare, the resulting injury has on occasion required the amputation of a finger, a hand or in some cases the entire limb. The longer the delay in getting professional medical aid, the further up the limb the tissue damage can spread. An injury of this type can become very serious or even fatal if not dealt with promptly and properly. In the event of any suspected fluid injection injury • Report the injury to your supervisor IMMEDIATELY.

Failure to follow all of the above instructions could result in serious injury or death from crushing.

• Seek professional medical attention IMMEDIATELY. 1.25


Turn static files into dynamic content formats.

Create a flipbook

Articles inside

WHAT TO DO WHEN A MACHINE FIRE OCCURS............................................................................1

1min
page 32

DRY CHEMICAL CLEANUP PROCEDURES......................................................................................1

22min
pages 34-42

WHAT TO DO AFTER A MACHINE FIRE HAS OCCURRED..............................................................1

2min
page 33

COOLING SYSTEM......................................................................................................................1.24, 1

4min
pages 43-46

LOOSE CLOTHING HAZARD.................................................................................................................1

1min
page 24

WHAT TO DO TO PREPARE FOR A MACHINE FIRE........................................................................1

1min
page 31

ELECTRICAL COMPARTMENT - CAB...................................................................................................1

1min
page 22

HARVESTER

5min
pages 19-21

TRACK DRIVE

1min
page 11

SWING

1min
page 15

LOADER, PULPWOOD/LOG GRAPPLE

1min
page 16

BACKOVER ACCIDENTS – AVOIDING....................................................................................................1

1min
page 8

PILOT SYSTEM

1min
page 5

LOADER, BUTT 'N' TOP/POWER CLAM GRAPPLE

1min
page 17

HARVESTING ATTACHMENT – GENERAL SAFETY ............................................................................1

2min
page 13

CHAIN SHOT ..........................................................................................................................................1

2min
page 18
Issuu converts static files into: digital portfolios, online yearbooks, online catalogs, digital photo albums and more. Sign up and create your flipbook.