Tigercat 718 Feller Buncher
Safety
GENERAL SAFETY PRECAUTIONS
KEEP BACK 500 FEET
Remember that safety is a prime responsibility of all. To minimize the risks and promote safety at all times, this section of the operator’s manual details a number of safety rules which should always be followed and obeyed. Always read the operator's manual before operating the machine. Pay close attention to WARNINGS and HAZARD identifications
When approaching an operating machine on foot, stay at least 500 feet (150 meters) away until the operator recognizes your presence. Make sure that all harvesting equipment has been shut down before advancing to the machine.
DANGER ROTATING SAW The safety of persons outside the cab is the responsibility of the machine operator
Follow all instructions from safety inspector and supervisors. You must be fully trained to operate this piece of equipment. Know the capabilities and the limitations of the equipment. Learn the most efficient operating techniques.
Wear a suitable hearing protective device such as earmuffs or earplugs to protect against noise. Prolonged exposure to loud noise can cause impairment or loss of hearing.
Do not let an untrained person operate the machine.
Use the handrails and steps provided when mounting and dismounting from the machine. Do not climb onto or jump off the machine at any time. Do not try to climb onto or off a moving machine. Do not use the joystick(s) or steering wheel as a handle to assist entering or leaving the cab. Do not use the machine foot controls as a step.
Use recommended protective clothing and safety devices such as orange safety vest, gloves, safety boots, safety hat, goggles, and ear protection when necessary. These safety rules highlight both general and specific measures the operator should be familiar with and adhere to. More specific measures are illustrated with pictograms which may also be attached to the machine in locations pertinent to their respective message. Keep safety labels in good condition. Repair or replace damaged labels. 1.3
When mounting or dismounting the machine always use the 3 point technique - Use 1 hand with 2 feet or 2 hands with 1 foot.
