Removal and Installation of Turbo Charger

[5]Remove the element (8) and O-ring (9) and replace them.

[6]After replacing the filter, attach the cover (7), then tighten it by tightening it 1/3 - 2/3 turn with the specialty filter wrench.

[7]Open the fuel line (1) stop valve (2).

2.Air Bleeding

If air gets into the fuel system, this can cause difficulty starting and poor engine condition. When the fuel tank has been emptied, water drained from the fuel, the element replaced, or other such work carried out, always bleed the air. [1]Install the air bleed hose (1) at the position in the diagram on the right. [2]Use a wrench (10 mm) to loosen the air bleed plug (3).

[3]When the filter case priming pump is turned in the direction of the arrow, the knob (2) pops out.

[4]Press the knob a few times.

When fuel appears inside the filter case, lightly tighten the air bleed plug (3). Press the knob (2) a few times in this state.

Finally, hold the knob pressed in and slightly loosen the air bleed plug (3).

Fuel oozes out from the hose (1) like bubbles. [5]Repeat the operation in [4] until no more bubbles appear. [6]Tighten the air bleed plug (3), then turn the knob (2) and lock it.

Charge Fuel Pump Filter Replacement

Caution ・ Be sure to stop the engine before beginning work.

Items to prepare •Box wrench (19 mm) •Wrench (10 mm) •Pliers •Cap •Rags •Cleaning fluid 1.Charge Fuel Pump Filter Removal [1]Use a box wrench (19 mm) to remove the 2 bolts (1) and washer (2), and then remove the cover (3).

[2]Remove the connector (4).

[3]Use pliers or another tool to loosen the hose bands (5), and then remove the hoses (6) and (7). •Use caps to cover the charge fuel pump filter and hoses to prevent the entry of water, dust or dirt.

[4]Use a wrench (10 mm) to remove the 2 installation bolts (8), and then turn the filter cover (9) to the left and remove the element (10).

2.Charge Fuel Pump Filter Installation

To install, perform the reverse of the removal procedure.

Tighten bolts being installed to the specified torque.

For bolts for which the torque is not specified, check page1 of the "About This Shop Manual Section • Tightening Torque • Retightening Torque Table" in the explanation in the materials.