DIAGNOSTIC TOOLS & PROCEDURES

If more than one active fault is present, continue the blink code sequence until the first active fault is displayed again to be sure all faults have been recovered.

The V-MAC II blink code software will not provide codes for inactive faults. To access this data, use the Pro-Link 9000 or PC.

The next section includes a list of possible blink codes.

Diagnostic Blink Code Identification Chart

The following table lists the possible faults which may occur in the V-MAC II system. After obtaining the active fault code sequence, find the code in the table to determine where to begin troubleshooting procedures. Then turn to the page listed in the Table of Contents or Index for the appropriate diagnostic test section.

Page 23