REPAIR INSTRUCTIONS

21.Install the Lo/reverse sliding clutch onto the mainshaft.

23.Install the snap ring retaining the reverse gear to the mainshaft, using suitable snap ring pliers. Install snap ring into the fifth snap ring groove from the rear of the shaft.

22.Install the reverse speed gear onto the mainshaft with clutch teeth facing the sliding clutch. The reverse speed gear thrust washers and remaining snap ring will be installed after the mainshaft has been installed into the case, during transmission reassembly.

24.To make it easier to install the mainshaft into the main case:

Slide the Lo/reverse sliding clutch forward until it engages the Lo-speed gear.

Slide the reverse speed gear over the Lo/reverse sliding clutch until fully engaged.