REPAIR INSTRUCTIONS

1.Remove the gasket from the bearing cover. Discard the cover gasket.

2.Remove the snap ring securing the bearing in the rear mainshaft bearing cover, using suitable snap ring pliers.

4.Remove the oil seal from the rear mainshaft bearing cover, using a hammer and blunt punch. Drive the seal out from the opposite side. Discard the cover oil seal.

3.Remove the bearing from the rear

This action destroys the oil seal. Make sure a replacement oil seal is readily available.

5.Thoroughly clean the rear mainshaft bearing and bearing cover, and inspect for damage.

Rear Output Housing Disassembly: T313–T318(21)(L21)(LR21)

1.Remove the gasket from the bearing cover.

2.Using a blunt punch and hammer, remove the outer bearing cup from the output housing.

3.In

4.Thoroughly clean the rear output housing, and inspect for damage.