1 minute read
Operator ’ s Manual CO-PILOT® DISPLA Y
from Mack Truck Electronic V-MAC IV Vehicle Management & Control with Co-Pilot Display Operator’s Manual
Introduction and Purpose
The - Pilot - dash computer that lets the vehicle operator monitor information supplied the vehicle management and control - MAC) electronic control system and enhance the functions V - MAC entering requested information with the stalk switch. The - Pilot very and prompts the operator with messages the display screen.
Beginning withPilot, features include the following:
• Fuel Economy Information
• GuardDog™
• Driver T rip and Fleet T rip Information
• Speedometer Information
•
•
•
•
•
Gauge Information
Electronic Faults
Driver Messages
Cluster Diagnostics
Maintenance Monitoring (if available)
• Integrated T emp - A - Start (if available)
• Set - driver overspeed display lighting)
CO-PILOT SYSTEM OVER VIEW
Set-Up Programming
Many - Pilot features and functions listed this Operator ’ s Guide can customized meet individual company operator needs. V - MAC can easily programmed the dealer customer using MACK’ s scan tool with VCADS software make these features available through thePilot.
your - Pilot does not display any the features listed this Operator ’ s Guide, please consult your dealer appropriate fleet management personnel for V - MAC set - reprogramming required. Programmable - Pilot features include:
T able 4
Programmable - Pilot Features
The following illustration shows the areas the - Pilot® Current Conditions screen.
The stalk switch located the right side the steering column and contains three depressible buttons: ESC Enter ( ↵ ↵ ↵ ) and & Down . The stalk switch used access, navigate, view and change information available the driver information display (Co - Pilot® only).
The following illustration shows the stalk switch.
