2) 2nd crusher

10.)Assembling the holder (17)

Engage the inner teeth of the holder (17) with those of the sun gear (15), and then assemble the holder (17) onto the sun gear (15).

11.)Assembling the planetary gear (21)

Assemble the thrust plate (18) onto the planetary gear (21).

Next, assemble the needle bearing (20) onto planetary gear (21).

Lastly, after assembling the inner race (19), engage the bore section of the inner race (19) with the trunnion sections (at 3 locations) on the holder (17), and then assemble the planetary gear (21) onto the holder (17).

Note:

a.When assembling the thrust plate (18) onto the planetary gear (21), assemble so that the blanking mark on the thrust plate (18) left by the press comes on the side of the holder (17). b.In the last step for assembling planetary gear (21) onto the holder (17), assemble so that the inner teeth of the housing (4) are engaged with those of the planetary gear (21). c.Take care for the assembling direction for the planetary gear (21).

*1

*2

*1 Direct the blanking mark side to face holder B (17). *2 Assembling direction for thrust plate (18)

12.)Assembling the planetary gear (25)

Assemble the thrust plate (22) onto the planetary gear (21), and then assemble the thrust plate (23). Assemble the screw (24) with locktite applied on its thread section, and tighten to the specified torque.

Direct the spline side of the drive gear (25) to face the motor assembly. Assemble it in the center of 3 planetary gears (21) and engage the teeth of the planetary gear (21) with those of the drive gear (125).

Note:

a.Take care for the assembling direction for the planetary gear (22). b.Wash and clean the bore of the holder (17) and the thread section of the screw (24), and degrease them well.

*1

*2

*1 Direct the blanking mark side to face the planetary gear C (12). *2 Assembling direction for the thrust plate (13)