ISEKI TRACTOR SF300 Operation Manual - PDF DOWNLOAD

I

s EK I

T R A C T 0

,

Op era t I 0

ISEKI & CO., LTC.

R

I

INTRODUCTION

l

Thank you very much for purchasing an !SEKI front mower.

This operator's manual provides the information necessary for operating and maintaining your front mower safely and properly. The contents are mainly composed of the following two items: Safety instructions :

Essential items which you should observe while operating the front mower

Technical instruction :

Items which are necessary to operate, adjust, and service the front mower properly

Before starting to operate the machine for the first time, you should read this operation manual thoroughly and carefully until you are sufficiently familiar with the operation of the machine to do jobs safely and properly. The manual should be kept in a handy place so you can refer to it when required. You are advised to refer to it from time to time to refresh your understanding of the machine.

Paragraphs in the manual and labels on the machine which are accompanied by a caution mark contain particularly important information about safe operation to avoid accidents. You should always keep precautions in mind and follow them during operation.

Be sure to wear personnel protective equipment during operation!

All information, illustrations, and specifications contained in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.

The word "FRONT MOWER" means a combination of the tractor (driver) and the implement (mower).

-1-

I

CONTENTS

INTRODUCTION ....................................................................... 1

5. BONNET OPEN/CLOSE LEVER ............................ 17

I. FOR SAFE OPERATION ........................................................ 3

6. SAFETY SWITCHES .............................................. 17

• BEFORE STARTING THE FRONT MOWER ........... 3

7. WHEEL DRIVING MODE MANUAL CHANGE-OVER

• OPERATION OF THE FRONT MOWER .................. 3

LEVER .................................................................... 18

• OPERATION ON A SLOPE ...................................... 4

V. OPERATION ....................................................................... 19

• WHEN FILLING WITH FUEL .................................... 4

1. BEFORE STARTING THE ENGINE ....................... 19

• MOUNTING AND DISMOUNTING OF THE MOWER

2. STARTING THE ENGINE ....................................... 19

DRIVE SHAFT .......................................................... 4

3. STOPPING THE ENGINE ...................................... 21

• FRONT MOWER MAINTENANCE ........................... 4

4. OPERATION ........................................................... 23

• BEFORE STOPPING THE FRONT MOWER ........... 5

4.1. MOVING TO A WORKING SITE ............................. 23

• OTHER PRECAUTIONS .......................................... 5

4.2. MOWING OPERATION .......................................... 25

• CAUTION LABELS ON THE FRONT MOWER ........ 6

VI. MAINTENANCE ................................................................. 27

• POSITIONS OF THE CAUTION LABELS ................. 7

1. INSPECTION AND ADJUSTMENT ........................ 27

• MAINTENANCE OF THE CAUTION LABELS .......... 7

1.1. ENGINE OIL LEVEL ............................................... 27

• LOCATIONS OF THE MODEL NAME AND SERIAL

1.2. TRANSMISSION OIL LEVEL .................................. 28

NUMBER .................................................................. 8

1.3. REDUCTION GEAR CASE OIL .............................. 28

II. SPECIFICATIONS ................................................................. 9

1.4. REAR AXLE OIL LEVEL ......................................... 29

Ill. NAMES OF MAJOR COMPONENTS ................................. 10

1.5. COOLANT LEVEL .................................................. 29

IV. CONTROLS AND METERS ............................................... 11

1.6. FUEL LEVEL ........................................................... 30

1.1. STARTER SWITCH ................................................ 11

1.7. AIR-CLEANER ........................................................ 31

1.2. GLOW INDICATOR ................................................ 12

1.8. FUEL STRAINER .................................................... 31

1.3. THROTTLE LEVER ................................................ 12

1.9. FAN BELT ............................................................... 32

1.4. HEAD LAMP SWITCH ............................................ 12

1.10. CLUTCH PEDAL PLAY .......................................... 33

1.5. MONITOR LAMP ARRAY ....................................... 12

1.11. MASTER BRAKE PEDAL PLAY ............................. 33

2. FENDER (WING) PANEL ....................................... 13

1.12. NEUTRAL POSITION OF HST ............................... 34

2.1. TRANSMISSION RANGE SHIFT LEVER ............... 13

1.13. INDEPENDENT BRAKE PEDALS (LH & RH) ......... 36

2.2. PTO LEVER ............................................................ 13

1.14. BATTERY ............................................................... 36

2.3. LIFT LEVER ............................................................ 14

1.15. TYRE PRESSURE (INFLATION) ............................ 37 ,

2.4. CRUISE CONTROL LEVER ................................... 14

1.16. TOE-IN .................................................................... 37

2.5. HOUR/TACHOMETER ........................................... 14

2. REPLACEMENT OF OIL AND OIL FILTER ............ 37

2.6. FUEL GAUGE ......................................................... 14

2.1. ENGINE OIL REPLACEMENT.. .............................. 37

3. CONTROL PEDALS AND LEVERS ........................ 15

2.2. ENGINE OIL FILTER REPLACEMENT .................. 38

3.1. CLUTCH PEDAL ..................................................... 15

2.3. TRANSMISSION OIL REPLACEMENT .................. 39

3.2. MASTER BRAKE PEDAL ....................................... 15

2.4. REDUCTION GEAR CASE OIL REPLACEMENT .. 40

3.3. HST FORWARD TRAVEL PEDAL. ......................... 16

2.5. REAR AXLE OIL REPLACEMENT ......................... 41

3.4. HST REVERSE TRAVEL PEDAL ........................... 16

2.6. RADIATOR CLEANING .......................................... 42

3.5. INDEPENDENT BRAKE PEDAL (RH) .................... 16

2.7. COOLANT REPLACEMENT ................................... 43

3.6. INDEPENDENT BRAKE PEDAL (LH) ..................... 16

2.8. INSPECTION OF FUSES AND WIRING ................ 43

3.7. DIF-LOCK PEDAL .................................................. 16

VII. LUBRICATION CHART .................................................... 45

3.8. SEAT SUSPENSION CONTROL KNOB ................ 16

VIII. PERIODICAL INSPECTION TABLE ................................ 46

3.9. FORE-AND-AFT SEAT ADJUSTING LEVER ......... 16

IX. TROUBLESHOOTING ....................................................... 47

4. PARKING BRAKE LEVER AND TILT LOCK LEVER17

X. STORAGE ........................................................................... 53

4.1. PARKING BRAKE LEVER ...................................... 17

XI. ELECTRIC WIRING ........................................................... 54

4.2. TILT LOCK LEVER ................................................. 17

-2-