1 minute read
Monitoring slewing angle on/off à p. 1 - 19
Read entered limiting values You can check in the Working Range Limiter submenu which limiting values are entered for the individual monitoring functions.
HAll illustrations in these operating instructions use metric measuring units. Depending on the country in which you are working, the display can also be in US units of measurement; conversion is carried out at the factory.
The displays
show you both the maximum set value and the current value. – The values surrounded in red (displays (1) and (2) upper value, display (3) upper and lower value) always show the maximum set position. – The values surrounded in blue (displays (1) and (2) lower value, display (3) middle value) always show the values that correspond to the momentary position of the boom and the superstructure (current value).
HThe displays surrounded in blue only show the current value if the manual entry is switched off. When the manual entry is switched off, the value can be changed in the display as desired; à Entering limiting values manually, p. 1 - 17. 1 Maximum/Current total height 2 Maximum/Current working radius 3 Maximum/Current slewing angle
The values for the point data of individual objects can only be read for objects in the Point data entryfor objects submenu; à Enter point data for objects, p. 1 - 14.
