Gehl Mower Conditioner MC1070 1090 Service And Parts Manual(902579) - PDF DOWNLOAD

Form No.

902579 Replaces

902273

:J

I w SERVICE PARTS MANUAL

l!J

MC1070/1090 - INTRODUCTION Mr. Dealer:

Standard hardware torques appear in a chart at the end of the manual.

When ordering service parts, specify the correct part number, full description, quantity required, the unit model number and serial number.

Numbers for this unit are stamped on a plate which is located on front left side of the Main Frame.

Unless otherwise specified, all Cap Screws or Bolts are Grade 5, cadmium or zinc plated; Hexagon Nuts for Grade 5 Cap Screws or Bolts are Grade B; Hexagon Nuts for other Cap Screws or Bolts are Grade A.

"Right" and "Left" are determined from a position standing behind the unit and facing the direction of travel.

From this position, the Transmission and Drive Line are on the "Left" side.

GEHL Company reserves the right to make changes or improvements in the design or construction of any part of the unit without incurring the obligation to install such changes on any unit previously delivered.

NOTE: On original Tire replacement, Company policy prohibits the sale of replacement tires for all original GEHL machinery. Replacement Wheel Sets are available and tire size information is calledout with the Wheel Sets to facilitate replacement tire selection. ALL REPLACEMENT TIRES MUST BE PURCHASED LOCALLY. NOTE: Common hardware, such as nuts, cap screws, etc. are listed in the parts list but NOT illustrated. Hardware listed, is for mounting purposes and NOT included when the part is ordered for replacement. For the part numbers of common hardware, refer to the attaching hardware table located inside the back cover.

The following abbreviations are used in this manual: The following abbreviations are used in this manual: CB HHCS RHMS SHSS HJN HLN HN SN LW PW NF SL T SQ

-

Carriage Bolt Hexagon Head Cap Screw Round Head Machine Screw Socket Head Set Screw Hexagon Jam Nut Hexagon Lock Nut Hexagon Nut Slotted Nut Lock Washer Plain Washer National Fine (Thread) Self-locking (Thread) Tooth Square

TABLE OF CONTENTS Page Introduction ..................................................... ................... Inside Front Cover Table of Contents ..................................................... ............................... I Decal Location ..................................................... ............................... 2-3 Main Frame (MCI070) ..................................................... ........................ 4-6 Main Frame (MCI090) ..................................................... ........................ 7-9 Drawbar & Jack ..................................................... ............................ 10-11 Windrower ..................................................... ................................. 12-13 Sickle & Cutting Mechanism ..................................................... ................. 14-16 Roller Drive Transmission ..................................................... ...................... 17 Reel (MCI070 Before Serial #4101 & MCI090 Before Serial #8702) ..................................... 18-19 Reel (MCI070 After Serial #4100 & MCI090 After Serial #8701) ........................................ 20-21 Roller & Drive ..................................................... ............................. 22-24 Trans mission & Drives ..................................................... .......................... 25 Tubular Drive & Roller Drives ..................................................... ................... 26 Telescoping Drives ..................................................... ............................. 27 Input Transmission (540 RPM) ..................................................... .................. 28 Input Transmission (l000 RPM) ..................................................... ................. 29 Accessories ..................................................... .................................... 30 Hitchjack ..................................................... ..................................... 31 Notes ..................................................... ........................................ 32 Numerical Index ..................................................... ............................ 33-35 Notes ..................................................... ........................................ 36 Torque Specifications for Standard Machine Hardware ..................................... Inside Back Cover Attaching Hardware Table ..................................................... ........ Inside Back Cover