w/Tapered Bearings

How to Remove the Countershaft Assemblies (w/Tapered Bearings)

For "A" Series, go to “A” Series Section.

For ease of disassembly, mount the auxiliary section upright in a vise.

Both countershafts are removed the same.

Make sure the countershaft retaining straps are installed.

As the countershaft strap is removed, support the countershaft; it can fall.

• Typical Service Tools • Vise with brass jaws or wood blocks • Bearing puller • Soft bar and a maul

1. On the output shaft, temporarily install a output yoke.

2. To keep the output shaft from turning, insert a breaker bar.

3. From the output shaft, loosen the 15/16" capscrew and retainer. Do not remove the capscrew. Remove the bar and output yoke.

4. Use a sort bar and maul to drive the output shaft forward far enough to partially unseat the bearing.

5. Support the auxiliary countershaft while removing the auxiliary countershaft retaining strap.

6. Remove the auxiliary countershafts.

7. If necessary, secure the countershaft assemblies in a vise and remove both the front and rear bearings with a bearing separator and jaw pullers.