Ring Gear Installation

Figure 127 Install differential flange half. NOTE: Align identification marks as shown.

Figure 128 Apply Loctite 262 or equivalent to (2) cap screws and install.

Figure 129 Tighten (2) cap screws to 24-27 Nm [18-20 LBF/FT]. Figure 130 Clean foreign material and/or cured thread locking compound from holes with M16x2 tap. Remove remaining residue from holes.

Figure 131 Use hone stone or file to remove nicks or burrs from mounting face. NOTE: Be sure to remove all abrasive residue.

Figure 132 Use hone stone or file to remove nicks or burrs from mounting face. NOTE: Be sure to remove all abrasive residue.

Ring Gear Installation