Install the shuttle tee hydraulic valve (4) the straight connector (5) .

MILSCO seat armrest installation

From the left - hand side the seat move the plastic pad cover and then disassemble the pad and the pad support removing the fixing hardware. Discard the pad and the pad support and the fixing hardware. Slide forward the cab seat and remove the two rear seat fixing bolt, then slide back the seat and remove the two remain front fixing bolts. the right - hand side seat, install the two washers 10.6x25x6 (28) and then left - hand side install the joystick armrest assembly (30) between the seat plate shown in the figure. Reinstall the cab seat. Secure with the four screws (32) . Connect the harness connector XLFT_A existing cab harness connector CAB_L and the harness connector XLFT_2 existing cab harness connector CAB_L2 located behind the seat.

GRAMMER seat armrest installation

NOTE: the joystick steering armrest is provided with the MILSCO bracket installed the armrest. is necessary replace it with the GRAMMER bracket.

From the left - hand side the seat, move the plastic pad cover and then disassemble the pad and the pad support removing the fixing hardware. Discard the pad and the pad support and fixing hardware.

Disassemble the MILSCO bracket from the armrest removing the four fixing screws. Discard the MILSCO bracket.

Install the GRAMMER bracket (33) the armrest reusing the same four fixing screws.

LEIL17WHL1712BB 14

LEIL17WHL0418AB 15

LEIL17WHL1713AB 16