Disconnect the power connectors at the rear of the cab 7

Removing the cab

Installing the spreader bar

Important:The screws must be screwed tightly into the lifting supports on the cab. The load must be lifted vertically. Before lifting, check the state of the screws, especially the threads, and check for distortion. If necessary, replace with screws n° 7703001749 only.

Operation n° 3

– Use lifting bar n° 7701388907 and the screws and washers of kit n° 7711132317. – Screw in the lifting screws tightly at the points provided. – Centre the lifting bar.

841msm01 Fig. 5

Operation n° 4

– Lift the single cover. – Remove the engine side covers.

841hsm06 Fig. 6