Error codes
List of error codes Error code
Native code
Sender module
Id75C0h
301
TR1 (A57-1)
Designation
Inconsistent current measurements obtained on the forward gear solenoid valve.
Cause/System response
Comment/Solution
Audio warning:: No.
Check:
"ISC" reset requested: No.
– The "Auto 5" module using tool n° 60 05 033 249, and change if required.
A different value is received from each of the two measuring points on the return. The "Auto 5" working with the estimated current.
Id75C1h
302
TR1 (A57-1)
Inconsistent current measurements obtained on the reverse gear solenoid valve. A different value is received from each of the two measuring points on the return. The "Auto 5" working with the estimated current.
Id75C2h
TR1 (A57-1)
Supply voltage measured on the Audio warning:: Yes. forward gear solenoid valve "ISC" reset requested: Yes. when the driver is not controlled (setpoint PWM = 0).
Id75C3h
304
TR1 (A57-1)
Supply voltage measured on the reverse gear solenoid valve when the driver is not controlled (setpoint PWM = 0).
Id75C4h
305
TR1 (A57-1)
Actual current measured on the return of the forward gear solenoid valve is too high relative to the setpoint.
Id75C5h
Id75C6h
Id75C7h
10
303
306
307
308
TR1 (A57-1)
TR1 (A57-1)
TR1 (A57-1)
Actual current measured on the return of the reverse gear solenoid valve is too high relative to the setpoint.
The current consumed by the forward gear solenoid valve is greater than 1,4 A (maximum allowable).
The current consumed by the reverse gear solenoid valve is greater than 1,4 A (maximum allowable).
Arion 430-410 – 04.2010 – GB
Check: – For a possible 12 V short circuit on the solenoid valve power supply harness. – The "Auto 5" module using tool n° 60 05 033 249, and change if required.
Check: – For a possible 12 V short circuit on the solenoid valve power supply harness. – The resistance of the solenoid valve winding. – The "Auto 5" module using tool n° 60 05 033 249, and change if required.
Check: – The solenoid valve if 301/302 are not shown. – For a possible 12 V short circuit on the solenoid valve power supply harness. – The resistance of the solenoid valve winding. – The "Auto 5" module using tool n° 60 05 033 249, and change if required.
