OPERATING INSTRUCTIONS Inspection and servicing ENVIRONMENTALLY COMPATIBLE HYDRAULIC FLUID 2804212
Environmentally compatible hydraulic fluid - operating instructions The hydraulic system of this machine can be filled ex works with environmentally compatible, synthetic hydraulic fluid as an option. In this case, the machine is supplied with stickers containing the corresponding instructions. For the initial filling, Terex Germany uses only: PANOLIN HLP SYNTH 68 Terex Germany (P/N: 2115005). This synthetic hydraulic fluid has been tested by Terex Germany and approved for application in Terex Germany machines. A change from mineral hydraulic oil to this synthetic hydraulic fluid can, however, be made also at a later date. Environmentally compatible hydraulic fluid, too, must not be simply poured away but disposed of in the same way as used oil. If hydraulic fluid seeps into the ground, the machine owner and the competent authorities must be informed. HLP SYNTH 68 is suitable only for hydraulic systems. As HLP SYNTH 68 is not soluble in water This means that condensate may be deposited in the hydraulic oil tank. It must therefore be drained off at regular intervals and after lengthy downtimes, then disposed of in the same way as used oil. Use only HLP SYNTH 68 for changing or topping up the hydraulic fluid. The hydraulic fluid must not be mixed with hydraulic oils or hydraulic fluids by other manufacturers, as this affects its biodegradability.
3-10
Operating equipment and attachments driven with mineral hydraulic oil must not be mounted until thoroughly emptied, cleaned and flushed. Analysis will show whether the hydraulic fluid can be used beyond the standard changing intervals. See section: "Environmentally compatible hydraulic fluid, sampling"
Environmentally compatible hydraulic fluid, conversion
Read and observe: "Inspection and Servicing - Safety Instructions".
Ü Bring hydraulic system to operating temperature. Ü Retract all hydraulic cylinders. Ü Drain off hydraulic oil (see operating instructions, section 3 "Inspection and Servicing"). Ü Fill hydraulic oil tank with HLP SYNTH 68 up to halfway mark. Ü Activate all hydraulic functions including travelling for about 30 minutes. The hydraulic system is being flushed during this time. Ü Then drain off the hydraulic fluid. The fluid can be used repeatedly for flushing. Otherwise it must be properly disposed of. In this case, a disposal expert must be consulted as this is a mixture of synthetic hydraulic fluid and mineral hydraulic oil. Ü Change all filters in the hydraulic system. Ü Fill the hydraulic oil tanks with new HLP SYNTH 68.
BA RH30F(3 663 960.00)-EN
